12/19/2023 0 Comments Rssi 63![]() To find out what signal qualities are supported, The response for the AT+CSQ comamnd is also interpreted for teh corresponding dBm value. Point your web browser to to turn the LED on or to turn it off OR Run raw TCP "GET /H" and "GET /L" on PuTTY terminal with 192.168.4.1 as IP address and 80 as port Created for arduino-esp32 on 04 July, 2018 by Elochukwu Ifediora (fedy0) */ #include #include #include #define LED_BUILTIN 2 // Set the GPIO pin where you connected your test LED or comment this line out if your dev board has a built-in LED // Set these to your desired credentials.With Online AT Command Tester tool, you can get the signal level of the device. * WiFiAccessPoint.ino creates a WiFi access point and provides a web server on it. WIFI_TX_ANT_AUTO Selects the antenna for TX automatically. WIFI_TX_ANT1 Selects the antenna 2 for all TX activity. WIFI_TX_ANT0 Selects the antenna 1 for all TX activity. WIFI_RX_ANT_AUTO Selects the antenna for RX automatically.įor the tx_mode you can use the following configuration: WIFI_RX_ANT1 Selects the antenna 2 for all RX activity. WIFI_RX_ANT0 Selects the antenna 1 for all RX activity. Return true if the configuration was successful.įor the rx_mode you can use the following configuration: Gpio_ant2 Configure the GPIO number for the antenna 2 connected to the RF switch (default GPIO25 on ESP32-WROOM-DA) Gpio_ant1 Configure the GPIO number for the antenna 1 connected to the RF switch (default GPIO2 on ESP32-WROOM-DA) Bool setDualAntennaConfig ( uint8_t gpio_ant1, uint8_t gpio_ant2, wifi_rx_ant_t rx_mode, wifi_tx_ant_t tx_mode )
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |